Paraffin solutions, surface active agents, UV absorbers, pigments and anti-separation additives are some of the additives Poliya can offer for your specific needs.
Inhibitor solutions are mixtures containing inhibitors to increase gel time and shelf life of resins. Use ratios between 0,01%-0,08%.
Inhibitor solution can be added into the resin before the accelerator.
Additive 81 is an additive for colored gelcoat applications where color separation occurs and improves flow and leveling properties.
Additives used for increasing the UV resistance of parts. It is possible to add 0,1%-0,5% additive into resins or gelcoats.
First dissolve UV stabilizor inside gelcoat or polyester thinner. Then add this solution to the gelcoat.
Promotors are chemicals used in Cobalt-Peroxide systems to accelerate gel and curing properties of resins in RTM, hand lay-up and spray-up applications.
Additive A-8 can be used in polyester resins or gelcoats in ratios between 0,02%-0,20%.
Additives used for increasing the UV resistance of parts. It is possible to add 0,1%-0,5% additive into resins or gelcoats.
First; dissolve UV stabilizor inside gelcoat or polyester thinner. Then add this solution to the gelcoat.
LSA is polystyrene solution dissolved in a styrene monomer. It is used in hot molding systems (SMC-BMC) to prevent shrinkage.
Recommended ratio is 5%-30%
Used for eliminating trapped air inside gelcoats and resins.
Can be used between 0,05%-0,30%. Add into polyester resin or gelcoat and stir well.
LSB is polyvinyl acetate solution dissolved in styrene monomer. It is used in hot molding systems (SMC-BMC) to prevent shrinkage and improve surface quality.
Polivaks D-32 is a paraffin solution which is added to gelcoats before repair or topcoat applications.
Polivaks D-32 forms a thin film on the gelcoat surface and prevents air inhibition. It can be used between 1%-2%.
LSC is polyvinyl acetate solution dissolved in styrene monomer. It is used in hot molding systems (SMC-BMC) to prevent shrinkage and improve surface quality.
A surface-performing agent used to obtain smooth surface and prevent orange peel appearance. Use 0,01%-0,10%. Add to gelcoat and mix well.
LSU is saturated polyester which is used in hot molding systems (SMC-BMC) as LP (low profile ) additive.
Additive T-12 rheological additive increases viscosity and thixotropic index values of polyesters and gelcoats.
Additive ratios can be between 0,05%-0,20% based on resin or gelcoat amount.
En son haberlerimizden ve ürünlerimizden ilk haberdar olmak için lüten aşağıdaki alanları doldurunuz..